A solid and well finished planer thicknesser for the busy workshop.

Features:
• Precision Ground Cast Iron Beds
• 2hp Induction Motor
• 3 Knife Cutterblock for Superior Finish
• 10'' Planing Capacity
• 10'' x 7'' Thicknessing Capacity
• Rubber Coated Outfeed Roller
• 100mm diameter Dust Extraction Outlet
• Optional Wheel Base Available

Precision ground cast iron beds and a long tilting fence which can be positioned at any point across the table make this machine a delight to use. The 3 knife cutterblock is powered by a 2hp induction motor and is capable of a cut up to 5mm deep in a single pass.

To gain better visibility and access for thicknessing, both of the planing beds are hinged and swing out of the way, without using any tools. A dust hood / cutter gaurd is then swung into position and the conversion to Thicknesser is complete.

The feed roller drive, which features a rubber outfeed roller, can be disengaged during planing operations to save motor power and general wear on the machine.

Supplied with 3 knives, 100mm dust extraction outlet, 4 adjustable feet, 1.6m power cable and UK 3 pin plug.
Our planer thicknesser will run off any standard 13amp supply.

Specifications:
Surfacing width - 250mm (10")
Length of surfacing tables - 1085mm
Maximum depth of cut - 5mm
Fence tilt - 90 - 45 degrees
Table height - 856mm
Thicknessing capacity - 5-195mm (1/4"-7")
Length of thicknessing table - 600mm
Feed speed - 5.5m/min
Maximum depth of cut - 2.5mm
Cutterblock speed - 4000rpm
Number of knives - 3
Motor ( induction) - 1500w (2hp)
Dimensions (WxDxH) - 1100mm x 780mm x 1050mm
Weight - 150kg
Rating - Trade

It is essential to use dust extraction with a planer thicknesser. The extractor removes all the dust and chips which will otherwise build up, causing a blockage and eventually damage to the machine. Using an extractor also increases the life of the knives.